Our Travel Blog

Woke up to a pleasantly cool morning. Lyn had some laundry to do and I had nothing (specific) to do. We sat around outside for a while enjoying the more reasonable temperature of around 25°C. After lunch we headed off into the Cañon City to look around and do some shopping. We also stopped in at the local railway station to book some tickets on a train trip up the Royal Gorge tomorrow.

Lyn had found a couple of quilt stores on the web, so we took a walk around to find them, but they no longer existed.

I wanted to get some shopping and get the truck fueled up and washed, and Lyn wanted to get her hair cut, so we went our separate ways.

I was going to leave the next bit out, but here it is anyway. Late yesterday afternoon after we had descended the mountain road, a squeak had developed in, I thought, the front left wheel of the truck. I wasn’t sure if it was brakes, wheel bearing or something else. Given the recent issues with the truck, paranoia has well and truly set in so, as we passed a brake shop I made a quick exit from the road onto the forecourt. One of he mechanics took it for a test drive, brought it back and put it on the ramps and checked the bearings. He said he could hear the sound, but like me he wasn’t sure where it was coming from. He took off the left front wheel and checked the rotor and pads, again all was well. He gave me a couple of plausible explanations for the noise, and assured me that all was well, but he’d take the rest of the wheels off and check all the brakes. A good call! The left back inner brake pad had worn right down and was the cause of the noise. I am a little confused as to why this had happened as I changed all 4 rotors and all 8 brake pads not too long ago. Seven of the brake pads were fine, just this one worn right down. It certainly didn’t seem to affect the braking, but it wasn’t doing the rotor any good. Bottom line, two new rear rotors and sets of brake pads. The truck goes in tomorrow while we are on the train, although the shop spent over an hour  diagnosing the problem they didn’t charge me for that, and the final bill for the parts and labour was very reasonable with only 45 minute labour for installation.

Back at the trailer the inside temperature had risen to A/C level, so we switched it on for a couple of hours, after about 7 PM the evening starts cooling down enough to switch off the A/C and go to “natural ventilation”

Another outside BBQ and dinner, tonight. Life is good!

An early start this morning, the cool weather from yesterday continued, and we woke up to a chilly 15°C in the trailer. Our well practiced packing up went well, and from falling out of bed, having breakfast and getting on the road took almost exactly one hour.

After the last few trips with broken pipes, tires etc I must admit to being a little apprehensive about this one. As it turns out, I had good reason  for the apprehension; about 15 minutes into the trip the check engine light came on! I have a “black box” in the truck that gives me the 4 digit code that caused the light to come on, but there is no translation into English. I can however reset the light, so i did that and all was well. If the light stayed off I reasoned it couldn’t be too serious! About an hour later the light came on again, same code with no adverse effect, reset it and all was well for a few minutes! This time it came on again, and the truck went into “Limp mode” which limited its speed to 40MPH. Limp mode cleared itself,and I cleared the light. We were about 6 miles from a major town, so we continued to McDonald’s to get some free WiFi and a coffee. The coffee for the nerves, the WiFi to decode the code. Problem code equated to lack of fuel pressure at the injectors. First and easiest solution was to get some fuel additive with injector cleaner in it and chuck it in the tank, so I filled up with diesel, chucked in the additive and off we went.

All was good with the world. We started climbing, and climbing, and climbing. Out of respect to the engine I dropped the speed down to 35 MPH on some of the hills, at that speed the engine was still generating over 270 HP to keep us going, but keep us going it did. No more problems with lights or limp mode so whatever the problem was went away with either new fuel, the additive or both. We finally stopped climbing at 11,300 ft. Another 700 ft and oxygen would have been required if we were flying! At this altitude the temperature had dropped to 13°C, and there was some snow just off the side of the road.

Some General Views on the way through Colorado
Approaching the Summit at 11,300 feet.

Plus a couple of lunch time views

We then started the descent, with 12,000 lb of trailer behind you care has to be taken not to overheat the brakes, and not let the speed build up too much so that the brakes stand a chance of stopping you safely! Eventually we reached more level land at around the 7000 ft level. Probably the hardest day of driving I have had!

We made it to a nice modern RV park in Cañon City Colorado around 4:30. We got the trailer set up and I went to move the truck, it started… then cut out. The old problem was back, but like last time it was a quick fix. While fixing it I noticed some air bubbles coming from around the edge of the fuel filter housing. If you remember a couple of weeks back I put in a new fuel filter, the instructions explicitly said to only lightly hand tighten the filter. I guess my hand tightening wasn’t tight enough, I managed to get another half turn on it, enough to stop the air bubbles. Thinking back, if air could be sucked into the filter housing, that may explain the loss of fuel pressure earlier?

A very comfortable nights sleep with the temperature around 20°C. We were woken up by a loud single clap of thunder around 4:30, followed by about 2 minutes of rain. At our proper wake up time the temperature was around 22°C, so off with the air and all windows open. The temperature stayed this way for most of the day. It did climb to 25°C for a short while, but then dropped to 19°C as a thunderstorm went through.

We spent the day at the trailer, both days we have stayed here have been good choices weather wise, cooler and overcast. Lyn caught up with some quilting, or at least tried to. It seems every time she sewed a whole load of squares, either the top thread or the bobbin thread ran out without her noticing. She was not a happy quilter at times, I think she “sewed” three times more than she needed to.

It’s amazing how many small jobs need doing around the place, just like home really. The infamous rear camera had been working pretty well, but on the last trip it kept cutting in and out then just plain died. First diagnostic showed no power getting to the camera, that narrowed it down to a break in 35 ft of wire running from the back of the trailer to the front, often buried deep in the under body insulation. As I was scouting around looking for any obvious issues, I saw a wire hanging down near the trailer wheels. This was not a welcome sight as my first thought was that the electric brake circuit to the trailer had become disconnected. Closer inspection showed that the wire was in fact part of the camera system. I am still baffled as to how the wire got broken, but at least it was in an easy place to fix. Camera now working again!

Next issue was the stereo, if we ran the radio music would come through all 6 speakers, as it was supposed to do. If we routed the TV through the stereo, sound would only come from the back two speakers. I took the stereo out of the cabinet, played with a few connectors, nothing seemed to be amiss, but it now worked…. put it back quickly!!

Final fix for the day was the bed room slider, It had not been fully retracting recently, one side stayed about an inch further out than the other unless assistance was provided in the form of a push from the outside. The other day I noticed some damage to the wood on the underside of the slider, and decided I had better investigate.

Not having a clue as to this contraption worked I employed the age old method of “rip it apart until you see how it works”. Luckily only three screws had to be removed to reveal the secret. The damage to the wood occurred where it slid over a roller. I am assuming the roller had been adjusted a little too high and was putting too much pressure on the wood. There was room enough to reposition the roller away from the damaged area, and with the help of a hydraulic jack I was able to adjust it a little better. Slider now goes in and out a lot better.

A lot of the above is written as a record of what I have done, should I need to refer back to it later, as a bonus you get to read it!!

As the afternoon progressed the temperature hung around the 20°C mark, with strong winds and thunder at times, very pleasant for a change. I have started packing some of the stuff away for a semi-early start for our trip to Colorado tomorrow.

Another comfortable nights rest, I think I’ve got the A/C under control finally. After experimenting with opening and closing various vents the whole trailer cools to the same temperature. When we first started the sleeping area was about 10°C hotter than the living area! Conversely to get a decent sleeping temperature the living area was down at 18°C.

After breakfast Lyn made up a lunch and we headed out to Dead Horse Point, in Dead Horse State Park. Why was it called Dead Horse Point?? Well a couple of centuries back, a group of cowboys discovered the point of land on a cliff which was 2-3 miles long, with a narrow part that was only about 30 yds wide. Across this narrow part they could make a fence to corral the horses in. So being good little cowboys they got a whole load of horses in the corral from the surrounding area and then went off to round up some more. Water wasn’t a problem as the Colorado River was only about 2000 ft away. Unfortunately that 2000 ft was measured vertically over the cliff face. When the cowboys got back, the horses were dead.

As we left the main road to head off to the State Park, I caught a movement in my peripheral vision, there was a large animal in the field.

 I know it feels like we have traveled back in time now we are in Utah, but this was ridiculous.

OK it was a dinosaur museum!

The road to the Park was home to a few geo-caches, so naturally we (I, Lyn had little option being in the passenger seat) stopped to hunt for them.

Again, this will be more pictures than words, as I am sure the pictures are more interesting than my ramblings.

Above are two buttes named Monitor and Merrimac. They were named for two iron clad warships from back in the days of the Civil War.

Below are general views

Below are a couple of shots taken from our lunch stop.

As I mentioned at the beginning, the Colorado River was 2000 ft below the point.

As were looking out over the river there were a couple of bright blue patches visible

These looked like lakes, but the colour just seemed too vivid. In fact they were lakes, but they were there for commercial purposes. The area is rich in potassium chloride, which is used in fertiliser production. Water is pumped from the river into the rocks below the ponds, this creates a potassium chloride solution that is forced to the surface. The solution is left there to evaporate, bright blue dye is added to speed up the process, and then scrapers are used to remove the product.

One of our cache detours took us into an area of cacti, again many were flowering.

Ummm…. need to read up on using the macro setting!

The last surprise of the day was an oil well in the middle of nowhere.We headed back to the campsite, with a quick stop for fuel and some forgotten groceries.

As we descend the 2000 ft from the park the nice cool temperature of 26°C rose up to 34°C. At least that is a little cooler than the peaks of a couple of days ago.

Woke up to an overcast day and ONLY 26°C outside. Inside was a chilly 21°C. For most of the morning the A/C worked as it should have, it came on, it cooled down, it switched off. Repeated as necessary, unlike previous days where it had ran flat out from 8 AM until 11 PM!

This morning a little more maintenance was required, numerous thousands of bugs that had chosen the front of the trailer as an aiming point for their kamikaze mission practice had to be removed. Why can’t bugs learn to die without leaving blood and body parts all over the place.

I also needed to lubricate the 5th wheel hitch on the back of the truck, it had been a bit reluctant to spring back into the locking position recently. I, or more specifically my right index finger, can now attest to the fact that the locking mechanism springs back very well!

It was still cool enough at lunch time to sit outside for lunch, a first on this trip. We headed into town to do the weekly grocery shopping, then came back to the trailer to do nothing. The clouds cleared this afternoon, so the temperature started to rise up to 36°C, but the trailer maintained its cool.

We also managed an evening meal outside today, this is getting close to real camping!

I figured there have been enough photos over the last couple of days, so this is a photo free day.